Recent content by obviouslytom

My son and I are playing this. He plays on his PC for a bit and then I start it on mine since we share a steam account. We are having a lot of fun with it and I love that I finally have a system that I can put everything on ultra settings and still have it run incredibly smooth.

Has anyone put in a memory card and had an issue with printing afterwards? I put in a 512gb card and when I send something to print, it says "downloading" and does nothing. I turn off the machine and remove the card and it works again. I have it formatted correctly so I don't understand what is...

I will give your suggestions a shot. I am even having trouble getting the Bambu Labs filament to stick now and I did wash off the plate in the sink, but maybe I didn't do a good enough job. I will try again. Edit: Turns out I am an idiot. I thought that I had the cool plate and figured it was...

I have cleaned the build plate using isopropyl alcohol and I have it to a test and level each time. The glue worked last night for what I was printing, but this morning when I went to do the other half, it failed each time even after cleaning and applying glue. The filament is just not sticking...

Just upgraded from the Creality Ender 3 v2 to the Bambu Lab X1 Carbon w/AMS and I have been enjoying it. I am still figuring out what speed settings work the best since I have had 4 failed prints in a row because of how fast it was going. I am printing this...

It appears I am getting closer because this is not the first time that I have seen it crash from this error Edit: I ran sfc /scannow from the command prompt and it came back saying that it found corrupted files and that it successfully repaired them. I had this laptop running for hours...

Bios yes but how would you update the firmware on the nvme? Unless you are referring to the Intel chipset which is also up to date.

I changed the fast start option but I have no idea if that will really change anything. As for the troubleshooting, nothing came up when going through it. Could it be the SSD or the ram going bad? The SSD is a 1tb NVMe that I got from Microcenter a few months ago.

I have dumped and redone this laptop a few times now and I am constantly getting a Kernel Panic 41. The latest was 20 minutes ago and it says: Unable to open the Server service performance object. The first four bytes (DWORD) of the Data section contains the status code. Any ideas on how to...

From the help I got, mainly needed to be tuned. Since then, I have done some very minor leveling to the bed although I still get a little bit of spacing on the initial layer as you can see here when you zoom on and look at the left side compared to the middle. It's not affecting the print, but...

I took a series of screen shots of all the settings. I will put them all up in the morning. The biggest one was changing the base to brim (I think) and having the initial layer at 0.28 and having it go slow, plate temp of 65° C and 220° C for the extruder.

Has anyone here with the Ender 3 had success with using the USB port on the front when connecting to a computer? No matter what I have tried, the software can never find it

And finished. The settings that were changed obviously worked and I will see if I can set it as some sort of default. It is a simple stand for my Galaxy Watch.

Just got home and so far so good. It's at 30% done and doesn't seem to be having any issue at all