obviouslytom
Fully [H]
- Joined
- Feb 24, 2005
- Messages
- 29,906
I have the Ender-3 V2 printer and as far as I can tell I have a level bed, however when I get about 20 minutes into a print, if I am lucky to get that far, whatever I am printing will no longer stick to the bed and start to move. I am using the inland PLA filament and the box tells me to have a print temp between 215 and 230 C and I have set it in the middle around 222. The system defaults to having the bed at 50 C and I have tried different temps between 50 to 60 C. I am getting frustrated enough that I want to chuck the unit but my wife would kill me if I did and I have hardly printed anything because I cant get anything to stick.
Thoughts?
I am trying the glue stick trick but I doubt that will even work.
Thoughts?
I am trying the glue stick trick but I doubt that will even work.