Need help Building a dual Slocket Celeron system. ASUS P2B-DS

[Magic H8 Ball]

I have an ASUS P2B-DS and I want to run dual 1GHz (or higher) Celerons (100mhz FSB) on it.

I have two "Super Slocket III" slotkets... they are supposed to work with FCPGA and dual cpu.

Will the asus P2B-DS be able to go down to a core voltage of 1.75? I don't think the Super Slocket III has any voltage regulation.

I have not ordered the CPU's yet, but was looking at dual 1.1Ghz Coppermine Celerons.

 

[Stugots]

coppermine celerons are not SMP capable, the last celerons that could do SMP were the 533 p2 based ones. youll need p3's to do this.

 

[Magic H8 Ball]

damn. So I have to use a 0.25 micron process Celeron then? Is SMP support completely absent from the Coppermine and Tualatin core Celerons or is there a (even if it is difficult) solder-mod work around?

Are all PIII SMP capable? Specifically, are the Tualatin core PIII's SMP capable?

 

[Satyrist]

The P3 Tualatins with 512k of cache on them are dual-capable.

Just not the Celeron Tualatins.

And yes, for coppermine, you would have to go with PIII. (256k cache)