D
Deleted member 80813
Guest
I finally found some time to get some pics up of my X-QPack with system in it.
The system is an MSI K7N2GM-V mobo with and AMD 1700xp+ 1GB Corsair RAM LiteOn DVD-RW 2 Maxtor HDD an ATI/Sapphire Radeon 9600 vid and Turtle Beach Santa Cruz sound card. The temps are low 30s idle to mid 40s under load. I keep the Panaflo on low to cut the noise.
This image shows it next to the Chieftech it is replacing. The bay bus is an old PCMods controller. It handles the 120mm Panaflo and the led lighting.
As you can see there is room for a full sized Antec Neo480 (The optical drive is a LiteOn 1673 DVD-RW) (I still have some wire management to do)
It was tight getting the mobo tray to slide in so I had to pull the fan off and mount it AFTER I had the mobo in. The current HSF is a Thermaltake Volcano 9 with a Sunon fan. It is the loudest thing in the system. (I will be replacing it soon.)
Yes I have 2 hard drives in there. The second one is mounted in the 3½" bay. It is a very tight fit and new mounting holes had to be drilled. I think I will be adding some rails and mounting it up in the 5¼" bay.
The system is an MSI K7N2GM-V mobo with and AMD 1700xp+ 1GB Corsair RAM LiteOn DVD-RW 2 Maxtor HDD an ATI/Sapphire Radeon 9600 vid and Turtle Beach Santa Cruz sound card. The temps are low 30s idle to mid 40s under load. I keep the Panaflo on low to cut the noise.
This image shows it next to the Chieftech it is replacing. The bay bus is an old PCMods controller. It handles the 120mm Panaflo and the led lighting.
As you can see there is room for a full sized Antec Neo480 (The optical drive is a LiteOn 1673 DVD-RW) (I still have some wire management to do)
It was tight getting the mobo tray to slide in so I had to pull the fan off and mount it AFTER I had the mobo in. The current HSF is a Thermaltake Volcano 9 with a Sunon fan. It is the loudest thing in the system. (I will be replacing it soon.)
Yes I have 2 hard drives in there. The second one is mounted in the 3½" bay. It is a very tight fit and new mounting holes had to be drilled. I think I will be adding some rails and mounting it up in the 5¼" bay.