Hey All,
I am planning a custom case, that will be made without CNC/Laser. All cuts will be done by hand.
To add in mesh, the common method is to cut your hole and place the mesh on the inside of the panel.
This leaves a small step down between the panel and the mesh.
What are the possible methods to have the surface flush, and get that look as if those holes were all cut out?
THanks
I am planning a custom case, that will be made without CNC/Laser. All cuts will be done by hand.
To add in mesh, the common method is to cut your hole and place the mesh on the inside of the panel.
This leaves a small step down between the panel and the mesh.
What are the possible methods to have the surface flush, and get that look as if those holes were all cut out?
THanks