I used elevated command prompt (Win7 x86)
The commands I used say successful.
I run bcdedit and the values are not saved.
What is keeping them from saving?
The commands I used.
bcdedit / set {..........} kernel ntkrlICE.exe
bcdedit / set {..........} testsigning on
bcdedit / set {..........} pae ForceEnable
Yes I replaced .....with my UUID.
I was using this guide.
The pic there shows the values.
That guide is outdated. I believe it is missing the disable integrity command.
I have found an alternative here with a video here.
The commands I used say successful.
I run bcdedit and the values are not saved.
What is keeping them from saving?
The commands I used.
bcdedit / set {..........} kernel ntkrlICE.exe
bcdedit / set {..........} testsigning on
bcdedit / set {..........} pae ForceEnable
Yes I replaced .....with my UUID.
I was using this guide.
The pic there shows the values.
That guide is outdated. I believe it is missing the disable integrity command.
I have found an alternative here with a video here.
Last edited: