You can see on the Arctic webpage what you'd normally need:
What I've used is basically the long screws, some of the washers and the nuts, along with some spacers.
My solution is based on my card, a reference Radeon 290X. It's by no means a universal solution and I have no experience with a GTX 960. My 290X can consume up to 275W of power, a GTX 960 is about half that, so I wouldn't expect the VRM part to need the heatsinks. I ran without for a while until...
Not really, since it was never cooled in its original state. Most times, the memory chips will suffice without cooling. The VRM heatsinks are important though.
Yeah but it's still just a Realtek ALC 1150 chip and the Realtek drivers alone also works, but not the headphone amplification detection. Or atleast I don't remember it working correctly. I don't use any of the other software, just the modified Realtek driver Asus provides.
I often respond about Cerberus questions but I'm in no way involved in the design or manufacturing of the Kimera Cerberus, except for my unending whining about the red color scheme.
When I insert my headphones into a connector with amplification (on my board specifically the front port through header) it brings up a dialog box asking me what type of output device it is. If I choose "headphones", it will do an impedance check (and pop loudly). So if you don't have this kind...
Generally stacked fans don't work together because they're all limited by the lowest pressure/airflow of the bunch. You could certainly use the two Noctua fans "solo", I did with my card and it performs well when I changed them to exhaust (out the bottom) so heat doesn't go into the case. I used...
I have the Acer XR341CK with a FreeSync range of 30-75Hz I believe and LFC support. You do notice when it goes below 30Hz but it's not that your screen will be flickering, just a dropped frame or two. I haven't witnessed without LFC yet, but I've read it starts to insert BLANK signals showing as...
True, it's also just my opinion on the matter. I just don't want people to think the holes are an aesthetic feature, but an integral part of the case ventilation.
I don't know if Necere or anyone else made a direct comparison, also because you'd use different coolers for both scenarios. Still...
When you said "a tiny bit", auto-correct suggested you mean "a whole lot". Without that side panel perforation, top-down CPU heatsinks are generally not going to perform well and you miss the only good spot to mount two fans if you are using a full size GPU. Considering most people use...