![[H]ard|Forum](/styles/hardforum/xenforo/logo_dark.png){kind=logo}
Hi
I have toasted my ender 5 pro with a garbage file installed as a .bin file via SD card. After that it refuses to boot or to install any other bin files.
I downloaded and built marlin bugfix 2.1.1 for creality ender-5 pro board version 4.2.2 which produces two bin files and used a stlink for flashing the bootloader with no success.
To make a long story short I am wondering if anyone has a full flash upload from a 4.2.2 board, bootloader and firmware, that I could try to flash in one go via the stlink. I would very much like to get back to a working controller and right now I can't even be sure what is actually broken, the hardware or the software. (It can of course be as a bootloader and a firmware separately, just as long as they have both been found to produce a working board.)
Thanks in advance
[email protected]
I have toasted my ender 5 pro with a garbage file installed as a .bin file via SD card. After that it refuses to boot or to install any other bin files.
I downloaded and built marlin bugfix 2.1.1 for creality ender-5 pro board version 4.2.2 which produces two bin files and used a stlink for flashing the bootloader with no success.
To make a long story short I am wondering if anyone has a full flash upload from a 4.2.2 board, bootloader and firmware, that I could try to flash in one go via the stlink. I would very much like to get back to a working controller and right now I can't even be sure what is actually broken, the hardware or the software. (It can of course be as a bootloader and a firmware separately, just as long as they have both been found to produce a working board.)
Thanks in advance
[email protected]