Search results

Got mine over a week ago. (preordered in early May)

This man speaks troof.

350w is fine on my 3.4 Northwood. The Prescotts are gonna pull some more 'trons though.

Tandy 1000SX 7.16mHz, 384kb RAM, Tandy 16 Color 13'' monitor, dual floppy no mouse... no hard drive... ...

You still need to unsnap the 4 legs off the mount. It shouldn't take too much force. Just pull out on each leg until it passes over the ridges.

Caps=Capacitors. Desolder 'em, charge em up and toss 'em at people. Hehe, beats joy buzzers.

I bought a 480w ThermalTake PoS and the clunker barely put out 11 volts. I thought I killed my system somehow at first until I checked the voltages with a Fluke. Finally got it to boot barebones, and sure enough, the 12 volt supply was fubar. Dropped even lower under load until it shut off...

It will probably be unstable unless you match your memory and bus frequency. If an 1800+ is your chip, the RAM will NOT be the limiting component.

I've got a TR2-M2 (thermaltake) 3 speed on my 2800+ and it's super quiet in Fast speed. CPU temp ~32C. 10x better than my old Volcano 7+ Vacuum Cleaner

Try manually installing from the CD vice the installer (should be the setup.exe under the DVDDcdr directory). I've seen the install discs not recognize the hardware before and the web updater not recognize the install disc for the DVD codec.

I sold my old PNY 4400 to a guy who fried it and he also got it RMA'd for a FX5600, so I doubt it was a mistake. Better than nothing for a dead board I guess.

Dunno if you touched the RAM, but improperly seated RAM will give these indications.