my ftw3 oc to 2100 @ 1v but i have to set it to 2150 , no matter what i set it drops about 40 mhz. then settles at that number solid.
If i want 2000 i set 2040, it locks at 2010..mhz
Those noctua's spitting hot air from you aio into the case?
Well i took mine apart and re applied the paste. took like 1 or 2c off the temps. i found the thermal tape was barely touching one vrm. i fixed it.
one little tiny black squares on the end of the line of vrms.
have a good oc and max...
my 3070 zotac mini oc @ 1950ish boost never goes above 75. thats at 100% fan and it has only 2 fans and a smaller heat sink.. oh but i leave the side off the case.
hella funny, ill be selling this one since i got a ftw ultra 3080 in a week,
I flashed my zotac twinegde 3070 oc with asus tuf oc bios here with a asus bios and it bosts to 1965 at stock and settles 1935 lowest ive seen 1910. if it gets like up to 75c
it doesnt really go up and down since the it has the limits relaxed to 365 wats.
i would set a fan curve on it , with...
I had the same problem . like 8-10c higher temp then the cheap stuff i had. I sent it back and got the cooler master nano stuff. about 10c lower temp..
well i tried again using d-15s and 82c was highest in prime 95. i just put sinth thermal elixer 2 from frys on [again] and guess what 68c so either fake or bad batch
Update:
An Indian Guy after a few mins of chatting said he would process a refund 3-5 days.. I called 2 days later again and it was never processed. The new guy sounds Philippine[ always somebody with an accent and hard to understand] Said the same thing he will process a instant refund this...
ste-2000 v Kryonaut [amazon]
over 10 c higher with grizzly paste.
Ive cleaned and swapped back and forth pastes, a few times to verify.
What is happening?