Recent content by stormy1

A big PS lightly loaded will hold up longer because it has bigger capacitors however under heavier load that changes. Under 10ms is considered to be the target for a good UPS.

Anker Solix C800 Plus has a 20ms switching time, not quick enough for a PC.

They dont have a fast enough switch over time to replace a UPS. However you can plug a USP into one for extended run time if the output is good enough not to trigger the UPS all the time. I know people who do it with ecoflow units combined with APC or Cyberpower true sine wave UPS..

More timing and side channel vulnerabilities in 3 2 1 GO!!!!

200mm fan blowing up through the desk with stands to raise the notebook a bit is still the best option.

pci-e allocation issue? check the docs for shared lanes.

tall box with a big ^ hat with outlet vents under the overhang,, fans a few inches up from the bottom blowing up, projector 2/3 up from the bottom. Mount with most of the bottom open a min of 4 feet off the ground or other flat surface.

Cut a hole in the desk and put a 200mm fan blowing up and some spacers under the back of the laptop to raise it slightly.

I have had good luck with Sabrent branded adapters/docks over the years. That one doesn't seem to say anywhere that it supports M.2 sata drives just M.2 NVME.

You need to separate the battery and charging system from the buck/boost except when the power goes out. This can be done with a diodes(low power) or a mosfet(high power) for near instantaneous switch over. Use a capacitor to smooth out the transition and the output after the buck/boost circuit...

There is a faq on sound issues and possibly firmware updates here: https://www.samsung.com/ie/support/model/UE49K5505AKXXE/

ts the tv not the soundbar. All the soundbar does is play what comes out on the cable. It does not know which app is supplying the sound. Contact support for the tv and they might have a firmware update

yes many of them are fan on full all the time vs fan only when on battery or at least reduced speed when not on battery. That said they will operate at higher room temperatures without throwing an error. In an industrial setting the Eaton will be running after the others error out.

There is a known issue with that card and sata ssd drives. Google: PERC H730 samsung 870 issue and PERC H730 sata ssd issue.

cable issue, also could be a firmware issue with the raid card, consumer sata drives vs sas drives can cause strange issues. Whats the part # on the raid controller?