Thermal pad thickness for EVGA 3060ti FTW3 Ultra

H

hairytoez

Limp Gawd
Joined
Mar 16, 2008
Messages
189
Just acquired the card in the title. Since I already have a full custom loop, I want to add it in and was curious if anyone had any info on what thickness pads to go with.
 
hairytoez said:
Just acquired the card in the title. Since I already have a full custom loop, I want to add it in and was curious if anyone had any info on what thickness pads to go with.
Click to expand...
It depends on the block you putting on it. Check the manual of the blocks you are interested. Typically the pads you will need come with the block.
 
Found a pcb pic of the 3060 ti ftw but didn't have time this morning to try to find a 3060 ti XC pcb
 
1639425489372.png

1639425345942.png


quite a different layout.
 
1639435482982.png

1639435501296.png


what i was saying about comparing the 3060(top) vs 3060ti for the bykski block, seems they are very close, pcb is even the same just those couple different chocks(?) **inductors on the right*. it might work...
*and the extra cap and vrm bits on the left. if the block isnt milled funny and clears those it should work.

i also just realized we kinda tread jacked, sorry op!
**edit, remembered what they were
 
Last edited:
After looking at the block. Also saying the design is still the same. You will see the 3060 block will need machined to fit the extra cap on the left. Arrow in the picture. If I had one of them I would look into machining it.

As mentioned. OP sorry to threadjack.
 

Attachments

  • 554545_1639435501296.png
    554545_1639435501296.png
    3 MB · Views: 0
  • 1f79cfca-e856-48e6-94a3-17a0e43badd9_800x.jpg
    1f79cfca-e856-48e6-94a3-17a0e43badd9_800x.jpg
    82.1 KB · Views: 0
Ducrider748 said:
After looking at the block. Also saying the design is still the same. You will see the 3060 block will need machined to fit the extra cap on the left. Arrow in the picture. If I had one of them I would look into machining it.

As mentioned. OP sorry to threadjack.
Click to expand...
yeah thats the bit i was wondering about. was hoping it was milled further up.
 
Ducrider748 said:
It's not. I have access to a cnc mill if I had a block. Aliexpress has them.
Click to expand...
as long as there isnt a water channel under it, it should be doable then...
might want to shoot them an inquiry email too. see if one is coming.
 
Back to the thread jacking........

After looking at pics of the other side the water passage looks a bit close to the outlet/inlet. I will try to get a block ordered and sent. Then get it clearanced for the cap. Will update on the results. Worse case is I will break through. For my use I will epoxy the hole. If I can get it to fit I will Def get with them on it and see if they will make a change.
 
You must log in or register to reply here.
Back
Top