Nobu
[H]F Junkie
- Joined
- Jun 7, 2007
- Messages
- 9,883
So I'm thinking about eventually putting together a loop using brass tubing and compression fittings (with ferrules), but being in the US, it's not exactly easy for someone not in the know to find 1/4" BSPP compression fittings that don't cost $8+ a piece.
What are your recommendations for fittings (part numbers/manufacturers) and where to get them?
Which supplier do you recommend for brass or copper tubing?
I saw this on amazon, does it look like it'd work? Legris 0101 10 13 39
Found these, much better price ($3/ea), but use o-rings instead of ferrules: Monsoon 1/2" OD Hardline Economy Compression Fitting (larger OD though, so I'd need bigger tubes)
Probably won't be starting this until I get some steady income, but I'd like to lay the groundwork now so I can just get everything I need and get to work once I do. Might help someone else who has the same question while I'm at it.
Edit 08/15: Added Monsoon fittings
What are your recommendations for fittings (part numbers/manufacturers) and where to get them?
Which supplier do you recommend for brass or copper tubing?
I saw this on amazon, does it look like it'd work? Legris 0101 10 13 39
Found these, much better price ($3/ea), but use o-rings instead of ferrules: Monsoon 1/2" OD Hardline Economy Compression Fitting (larger OD though, so I'd need bigger tubes)
Probably won't be starting this until I get some steady income, but I'd like to lay the groundwork now so I can just get everything I need and get to work once I do. Might help someone else who has the same question while I'm at it.
Edit 08/15: Added Monsoon fittings
Last edited:
As an Amazon Associate, HardForum may earn from qualifying purchases.