Recent content by drutman

Plastic sheets can be cut with scissors or exacto knife. Wife has paper cutter with a sliding blade for easy cuts. Use superglue or plastic cement to make cover using 90 degree joints. No PC or 3 d printer needed.

If you get Hard this is what you can do with the hobby and a PC /3d printer.

Hell yea Pend, Hard OCP approved, I do scale modeling so I would use sheet styrene and CA glue to make a cover. Non conductive too...

Once you go QD OLED for TV/HT you never go back. For PC use price would have to drop less than 500 USD for 32 inch for me to spend.

Price on this is what 1 kidney?

Mine is setup the same.

If you do any electrical work the Kein insulated set might save your behind if the circuit is live or when a slip of the tip may cause a short.

Go to link get a Klein branded electrician's Philips screwdriver...

To clarify it was the PSU to GPU PCI cables that were bad, the rest of the Cablemods were fine. I tried every HW swap and SW updates/uninstalls with no remedy. I used the cables that came with the PSU and has been trouble free for over a year.

Had a 41 kernel and constant reboot error and after HW swaps it was my cablemod PSU cable that was faulty.

Exactly what the Red ecosystem is for PC editing and video production and with Nikon acquiring Red they should open up rental market lowering cost. Cannon has the rental market for DSLR lenses.

Nice discussions here but until content is readily available, it is a no sell for me. As screens get larger the PPI drops and can look low res depending on size. Quality pixels over quantity factor, for example a 100K Christie 4K cinema projector is amazing just go to your local theater, no...

1. Any run of cable acts like an antenna, why pros use common noise reduction or XLR jacks. RCA plugs can be a noise machine especially with cheap cables. 2. You get what you pay for, my 200 USD Logitech PC 2.1 setup has a hum issue, my 1000 USD SVS sub does not. 3. Ground loops can be...

Scientifically the impurities are too low to worry about. Pure copper or some alloy it will eventually oxidize.